5
Product Category
Step 7 — Install the AAP Assembly
1. From under the table, push the rst AAP assembly
through the bottom of the enclosure. The holes in the
rear bracket must align with the bottom row of holes on
the rear face of the enclosure.
TIP: Ensure there is enough space above the AAP
assembly for the lid to close completely without
cables or connectors contacting the touchpanel.
2. Secure the AAP assembly into position with the
provided Phillips head screws.
3. Tighten the nuts that secure the AAPs to the brackets.
11
5
5
2
2
3
3
4
4
COMP
UTER
AUDIO
ws
ly)
Tighten down
AAP nuts.
Push assemb
bottom of enclosure.
Large slot
provides tool
access to fasten
rear brackets.
11
2
2
3
3
Extron
Step 8 — Mounting the Enclosure
Mount the cable cubby enclosure in the table.
CAUTION: The anged edges of the top of the surface enclosure are sharp. These edges are also soft and may be easily
nicked or bent. Exercise caution when handling the enclosure to prevent personal injury or damage to the enclosure.
ATTENTION: Les extrémités à brides du haut de la surface du boîtier sont aiguisées. Ces extrémités sont aussi lisses
et peuvent facilement être coupées ou pliées. Soyez prudents lorsque vous manipulez le boîtier an d’éviter de
l’endommager ou de vous blesser.
1. Remove the edge grommet protecting the edges of the trim ring
and the plastic lm on the nished surfaces.
ATTENTION: Do not use isopropyl alcohol or other solvents
to clean the Cable Cubby. Strong solvents will ruin some
nishes.
ATTENTION: Ne pas utiliser de l’alcool isoproprylique ou
d’autres solvants pour nettoyer le CableCubby. Les solvants
forts endommageront certaines nitions.
2. Carefully lower the enclosure into the hole cut in the table (see
Step2 — Cut the Surface on page 3). Ensure the trimring(
5
)
is ush with the top of the table.
3. Under the table, attach the table clamps (
3
) to the pins on
each side of the enclosure. It may be necessary to loosen the
wingnuts (
1
) and the Phillips head screws (
2
).
4. When the clamps are properly seated on the pins, tighten the
Phillips head screws until the clamp faces (
4
) are tightly secured against the bottom of the table.
5. To prevent the screws from becoming loose, secure the wingnuts against the table clamp bodies.
(2 strony)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Komentarze do niniejszej Instrukcji