Extron-electronics SW DVI A Series User Guide Instrukcja Użytkownika

© 2008 Extron Electronics. All rights reserved.Extron Electronics, USA1230 South Lewis StreetAnaheim, CA 92805800.633.9876 714.491.1500 FAX 714.

SW DVI A Series • InstallationInstallation, cont’d2-6SW DVI A Series • Installation 2-7Furniture mountingTo mount the SW DVI A switcher under a desk,

SW DVI A Series • InstallationInstallation, cont’d2-8SW DVI A Series • Installation 2-9b Video output connector — Connect a DVI-D display device to t

SW DVI A Series • InstallationInstallation, cont’d2-10SW DVI A Series • Installation 2-11DVI-I Video ConnectorsThe DVI-I video input and output connec

SW DVI A Series • InstallationInstallation, cont’d2-12SW DVI A Series • Installation 2-131. Wire the RS-232 cable to the ve-pole captive screw plug,

SW DVI A Series • InstallationInstallation, cont’d2-14SW DVI A SeriesTo enable autoswitching,1. Cut a small piece of wire to use as a jumper. 2. In

SW DVI A Series • OperationOperationSW DVI A Series • Operation 3-23-3 OperationsPowering on the switcherTo power on the SW2/SW4, 1. Connect all inpu

SW DVI A Series • OperationOperation, cont’d3-4SW DVI A Series • Operation 3-5Using the IR 102 remote controlThe hand-held IR 102 Remote Control lets

SW DVI A Series • OperationOperation, cont’d3-6SW DVI A Series • Operation 3-7Setting equalization for input sourcesHigh and low EQ levels for each in

SW DVI A Series • OperationOperation, cont’d3-8SW DVI A Series • Operation 3-9Loading the firmware to the switcherTo load a new version of rmware to y

SW DVI A Series • OperationOperation, cont’d3-10SW DVI A Series9. On the Choose Firmware File window, double-click on the new rmware le to open it.

Precautions This symbol is intended to alert the user of important operating and maintenance (servicing) instructions in the literature provided with

SW DVI A Series • SIS Conguration and ControlSIS Configuration and ControlSW DVI A Series • SIS Conguration and Control 4-24-3Using the Command/Respo

SW DVI A Series • SIS Conguration and ControlSIS Configuration and Control, cont’d4-4SW DVI A Series • SIS Conguration and Control 4-5Command ASCII C

SW DVI A Series • SIS Conguration and ControlSIS Configuration and Control, cont’d4-6SW DVI A SeriesAAppendix ASpecifications, Part Numbers, Accessorie

SW DVI A Series • Specications, Part Nubers, AccessoriesSpecifications, Part Numbers, AccessoriesSW DVI A Series • Specications, Part Nubers, Acces

SW DVI A Series • Specications, Part Nubers, AccessoriesSpecifications, Part Numbers, Accessories, cont’dSW DVI A Series • Specications, Part Nuber

SW DVI A Series • Specications, Part Nubers, AccessoriesSpecifications, Part Numbers, Accessories, cont’dA-6Cables and AdaptersThe following table li

安全须知 • 中文这个符号提示用户该设备用户手册中有重要的操作和维护说明。这个符号警告用户该设备机壳内有暴露的危险电压，有触电危险。注意阅读说明书 • 用户使用该设备前必须阅读并理解所有安全和使用说明。保存说明书 • 用户应保存安全说明书以备将来使用。遵守警告 • 用户应遵守产品和用户指南上的所有

iSW DVI A Series • Table of Contents Table of ContentsChapter One • Introduction ... 1-1About this

iiSW DVI A Series • Table of ContentsTable of Contents, cont’dSW DVI A SeriesChapter Four • SIS Configuration and Control ... 4-1Host-to-Sitcher

SW DVI A Series • IntroductionIntroductionSW DVI A Series • Introduction 1-31-2Independent input equalization — High and low equalization levels for e

SW DVI A Series • IntroductionIntroduction, cont’d1-4SW DVI A Series2Chapter TwoInstallationInstallation OverviewMounting the SW DVI A SeriesRear Pane

SW DVI A Series • InstallationInstallationSW DVI A Series • Installation 2-22-3Installation OverviewTo install and set up the SW2/SW4 switcher,1 Moun

SW DVI A Series • InstallationInstallation, cont’d2-4SW DVI A Series • Installation 2-5Use 2 mounting holes onopposite corners.(2) 4-40 x 3/16"Sc