Extron-electronics VN-MATRIX User Guide Instrukcja Użytkownika Pobierz pdf (Strona 12)

Section 1: Introduction VN-MATRIX User Guide

Page 12 I458GB issue 6

Control Capability

Source Control

Loop-through connections are provided on the VN-MATRIX for the source computer keyboard and

mouse. Local keyboard and mouse control of the source computer is fully maintained while connected

to the VN-MATRIX. In addition, keyboard and mouse functions can be remotely controlled from the

viewing station.

System Setup & Configuration

Low level communications setup of the VN-MATRIX is achieved using a serial data link to the COM1

port. High level configuration is achieved via the network using the Integrated Web Management

System (see below).

Integrated Web Management System

VN-MATRIX incorporates an Integrated Web Management System (Web Interface for short). This

allows any VN-MATRIX unit on a network to be configured via a PC/laptop (on the same network),

using a standard web browser (e.g. Internet Explorer, Netscape Navigator, Opera).

One VN-MATRIX unit on the network must be designated as a ‘controller’. This unit acts as a server

for the Web Interface and also holds a database of all VN-MATRIX devices on the network.

Any VN-MATRIX unit, whether it is configured as an encoder or decoder, can be used as a controller.

The Web Interface includes a full on-line help system.

Remote Control

RS-232 serial data can be routed between selected VN-MATRIX units, for example to provide remote

control of a source.

In addition, serial commands can be input to a VN-MATRIX and routed to the controller to allow basic

control of system operation, e.g. to change source selection on displays, compression settings, or

enabling and disabling devices.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 137 138

Brak uwag

Extron-electronics VN-MATRIX User Guide Instrukcja Użytkownika Strona 12