Extron-electronics SI 3 System INTEGRATOR User Guide Instrukcja Użytkownika Pobierz pdf (Strona 3)

Introduction

SI 3 Speakers • Introduction

About the SI 3 Speakers

The Extron System INTEGRATOR

™

SI 3 full range, compact,

surface mount speaker is ideally suited for classrooms,

conference rooms, and boardrooms. With a weather resistant

construction, it is also suitable for outdoor environments, and

has the following features (see below and page 2).

• 3" full range internal driver

• 75 Hz to 18 kHz, -10 dB frequency response

• 8 ohm nominal impedance

• 16 watts continuous pink noise

• 32 watts continuous program

• Internal driver overload protection circuit

Figure 2 — SI 3 speakers (with front grille removed)

N Refer to packaging information for location.

Carefully remove and check contents before installation.

N Extron recommends that the wiring installation be

performed by a professional audio equipment installer.

C Use cable clamps to hold the cables in place for

strain relief. Trim back/insulate exposed cable

shields with heat shrink to reduce the chance of

short circuits.

N For "Troubleshooting Tips" see pages 10 and 11.

N For "Service Access" see page 9.

1 2 3 4 5 6 7 8 ... 15 16

Brak uwag

Extron-electronics SI 3 System INTEGRATOR User Guide Instrukcja Użytkownika Strona 3