Extron-electronics DTP T UWP 232_332 D Setup Guide Instrukcja Użytkownika Pobierz pdf

IMPORTANT:

Go to www.extron.com for the complete

user guide, installation instructions, and

specifications before connecting the

product to the power source.

DTP T HWP/UWP D 232/332 D • Setup Guide

This setup guide provides instructions for an experienced installer to set up and operate the

Extron DTP T HWP D and DTP T UWP D family of wallplate extenders.

Installation

Step 1 — Disconnect Power

Disconnect all equipment power sources.

Step 2 — Prepare the Mounting Surface

ATTENTION:

• Installation and service must be performed by authorized

personnel only.

• The installation shall be in accordance with applicable

provisions of the National Electrical Code and any local

electrical codes.

NOTE: Use a wall box with a depth of at least 3.0 inches

(7.6 cm). Alternatively, the included mud ring (MR 200)

can be used. For more information, see the full product

user guide at www.extron.com.

a. Place the wall box against the installation surface and mark the

opening guidelines.

TIP: Use a level to mark the opening.

b. Cut out the material from the marked area.

c. Secure the wall box to the wall stud with 10-penny nails or #8 or #10 screws, leaving the front edge ush with the

surface.

d. Run all required cables (see steps 3, 4, and 5) and secure them with cable clamps.

TIP: In order to t the unit in the junction box, do not

install boots on TP cables and RJ-45 connectors.

Extron

DTP T UWP 232/332 D

Signal Output

Cable

Clamp

Decora Faceplate

Screws or

Nails

all opening is

ﬂush with edge of box.

Wall Stud

AUTO SW

CONFIG

IR OUT

HDMI IN

AUDIO IN

HDCP

AUDIO IN

VGA IN

AUTO SW

CONFIG

IR OUT

HDMI IN

AUDIO IN

HDCP

HDMI IN

AUDIO IN

HDCP

AUTO SW

CONFIG

IR OUT

HDMI IN

AUDIO IN

HDCP

AUDIO IN

VGA IN

TLP 1000TV

IPCP 505

IN1608

DTP HDMI 230 Rx

Projector

100-240V ~ -- A MAX

CONFIGURABLE

HDMI

RS-232 IR

Tx Rx Tx RxG

HDMI

INPUTS

OUTPUTS

Tx Rx

RS-232

LAN

2x25W(8Ω)/2x50W(4Ω)

RESET

AUDIO INPUTS

OUTPUTS

REMOTE

LL1R R

CLASS 2 WIRING

L5R

+48V

VARIABLE

IN1608 SA

MIC/LINE

SIG LINK

DTP IN

SIG LINK

DTP IN

SIG LINK

DTP OUT

50/60 Hz

RS-232 IR

OVER DTP

AMPLIFIED OUTPUT

VOLUME

SCALING PRESENTATION SWITCHER

IN1608

INPUTS

HDCP

SIGNAL

OUTPUTS

ENTER

Extron

2 3 4 5 6 7 8 A B C

INPUTS

1 2 3 4 5 6 7 8

CONFIG

Extron

DTP T UWP 232 D Tx

Transmitter

Extron

DTP T HWP 232 D Tx

Transmitter

Ethernet

A Typical DTP T HWP 232 D and DTP T UWP 232 D Application

Network

POWER

12V

0.7A MAX

AUDIO

SIG LINK

DTP IN

OUTPUTS

XTP DTP 24 Cable

230 '

XTP DTP 24 Cable

230 '

XTP DTP 24 Cable

230 '

HDMI

1 2345678

100

LINK

ACT

COM

IR/S

RTS

CTS

RELAY

FLEX

I/O

eBUS

ACT LIMIT

OVER

SWITCHED

12VDC

OVER

LIMIT

IPCP 505

1 2 3 4

Podsumowanie treści

Strona 1 - Installation

IMPORTANT:Go to www.extron.com for the complete user guide, installation instructions, and specifications before connecting the product to the power s

Strona 2 - Rear Panel

2DTP T HWP/UWP 232/332 D • Setup Guide (Continued)Step 3 — Connect Inputs to the TransmitterFront PanelA Audio input connector — Connect an unbalanc

Strona 3 - Step 7 — Final Installation

3DTP T HWP/UWP 232/332 D • Setup Guide (Continued)D DTP OUT connector — Connect one end of a twisted pair cable to this RJ-45 connector and the oppo

Strona 4 - Transmitter LEDs

68-2547-50 Rev. B03 14Extron Headquarters+800.633.9876 Inside USA/Canada Only Extron USA - West Extron USA - East+1.714.491.1500 +1.919.850.1000+1.7

Komentarze do niniejszej Instrukcji

Brak uwag

Extron-electronics DTP T UWP 232_332 D Setup Guide Instrukcja Użytkownika

Przeglądaj online lub pobierz Instrukcja Użytkownika dla Sprzęt komputerowy Extron-electronics DTP T UWP 232_332 D Setup Guide. Extron Electronics DTP T UWP 232_332 D Setup Guide User Manual Instrukcja obsługi

Podsumowanie treści

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Sprzęt komputerowy Extron-electronics DTP T UWP 232_332 D Setup Guide