Extron-electronics HSA 822MS User’s Manual Instrukcja Użytkownika Pobierz pdf (Strona 31)

HSA 822MS • Packaging for Shipment

Packaging for Shipment, Cont’d

HSA 822MS • Packaging for Shipment

Preliminary

Remove panel.

Remove two

screws ea. side.

HSA 822

Replacement Face Plate

Screws (4) under Enclosure

Figure B-3 — Removing the AAP/RJ-45 panel

The center screws on each side of the AAP/RJ-45 panel

do not fasten the AAP/RJ-45 panel in place. They secure

the AC power outlet.

CAUTION

Ensure that the edges of the AAP/RJ-45 panels do

not scratch the finish of the furniture in which the

HSA 822MS is installed when removing the panels.

d. Remove the two bolts and washers that secure the

tray to the underside of the HSA and remove the tray.

e. Disconnect any cables from the rear of the existing

AAPs. From the underside of the enclosure, reach

into the cable access holes (figure 3-1 on page 3-2,

item

), and cut the tie wraps (

shows the tie-

downs) that route the AAP cables inside the

enclosure. Carefully pull the cables through and out

the bottom of the HSA.

f. Remove the AAP(s) that you intend to keep from the

AAP/RJ-45 panels by unscrewing the nuts on the

rear of the AAP/RJ-45 panels that secure the AAPs in

place (figure B-4).

B-5B-4

#4-40 Nut w/ Captive

Washer

Cable

AAP/RJ-45

Panel

HSA 822MS

RGB 580xi SI AAP

COMPUTER

INPUT

SELECT

Figure B-4 — Mounting an AAP device

g. Use the two bolts and washers that you removed in

step d to reinstall the tray to the underside of HSA.

h. Remove and retain the four 1/4" nuts that secure the

top plate to the lifting plate (figure B-5) and remove

the plate.

Figure B-5 — Location of the top plate nuts

1 2 ... 26 27 28 29 30 31 32 33 34 35

Komentarze do niniejszej Instrukcji

Brak uwag

Extron-electronics HSA 822MS User’s Manual Instrukcja Użytkownika Strona 31

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Sprzęt komputerowy Extron-electronics HSA 822MS User’s Manual