Extron-electronics VGA Termination Kit Instrukcja Użytkownika Strona 1

Przeglądaj online lub pobierz Instrukcja Użytkownika dla Sprzęt komputerowy Extron-electronics VGA Termination Kit. Extron Electronics VGA Termination Kit User Manual Instrukcja obsługi

  • Pobierz
  • Dodaj do moich podręczników
  • Drukuj
  • Strona
    / 1
  • Spis treści
  • BOOKMARKI
  • Oceniono. / 5. Na podstawie oceny klientów
Przeglądanie stron 0
68-516-01 Rev. B
08 08
VGA Termination Kit Instructions
1. On the back of the connector, solder jumper wires from pin 6 to pin 7, from
pin 7 to pin 8, from pin 8 to pin 10, and from pin 10 to the shell (see the pinout
table on the back of this card).
2. Strip away approximately 1" of the outer jacket of the 5-wire coaxial cable.
3. Trim the outer foil shield back to a length of approximately 0.25".
4. For each coax cable:
a. Carefully strip away approximately 0.5" of
the jacket from the end of the coaxial cable
to expose the spiral shield.
b. Twist the spiral shield together and bend
the twist aside.
c. Carefully strip away approximately 0.25" of
the insulation to expose the center conductor.
Outer
Jacket
Insulation
Center
Conductor
1"
1/2" 1/4" 1/4"
Foil Shield
Spiral Shield
Outer Foil Shield
Pinout
PinCoax
1Red conductor
6Red shield
2Green conductor
7Green shield
3Blue conductor
8Blue shield
PinCoax
13Black conductor
10Black shield
14Yellow conductor
10Yellow shield
5
1
15
11
6
10
Jumper
d. Solder the center conductor of the cable to the pin’s
solder cup shown in the table below.
5.T
wist all of the conductors’ spiral shields (from 4b) together
and solder them to pin 10 or to the connector shell
.
6. Fasten the two halves of the backshell together around
the front plate of the connector using the provided
screws and nuts.
Twist all 5 shields
together and solder.
Center
Conductor
Solder Cups
Coax
Cables
Backshell
Jumper
Front Plate
Przeglądanie stron 0
1

Podsumowanie treści

Strona 1 - Backshell

68-516-01 Rev. B08 08VGA Termination Kit Instructions1. On the back of the connector, solder jumper wires from pin 6 to pin 7, frompin 7 to pin 8, fro

Komentarze do niniejszej Instrukcji

Brak uwag