Extron-electronics Annotator User Guide Instrukcja Użytkownika Pobierz pdf (Strona 46)

Using the Command/Response Table for SIS Commands

The command/response table follows this section. Lowercase letters are acceptable in

the command eld except where indicated. The table below shows the hexadecimal

equivalent of ASCII characters used in the command/response tables.

ASCII to HEX Conversion Table

•

space

Figure 23. ASCII to Hexadecimal Conversion

Symbols are used throughout the table to represent variables in the command/response

elds. Command and response examples are shown throughout the table.

Symbol Deﬁnitions

] = Carriage return with line feed

¦ or

} = Carriage return with no line feed

• = Space

E or W = Escape key

NOTE: If unit does not support or recognize the entered commands, nothing will

happen and no response is issued..

X! = Input selection, 1 to 7

X@ = Output selection:

0 = All outputs (default)

1 = Program only (BNC, MTP, optional output card)

2 = Preview only (VGA)

3 = None

X# = Input video format:

1 = RGB (default) 6 = Composite video

2 = YUVp/HDTV 7 = SDI

3 = RGBcvS 8 = HD-SDI

4 = YUVi 9 = DVI

5 = S-video 10 = Auto detect

X$ = H/V start — 0 to 255 (default midpoint = 128)

X^ = Pixel phase — 0 to 31 (default = 16)

X& = Total pixels — (±512 of the default value)

X* = Active pixels — (±512 of the default value)

X( = Active lines — (±512 of the default value)

X1) = Off/disable (0) or on/enable (1)

X1! = Input standard:

0 = No signal 4 = SECAM

1 = NTSC - = N/A (when input is set to a high resolution signal format)

2 = PAL

Annotator • SIS Communication and Control 40

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 107 108

Brak uwag

Extron-electronics Annotator User Guide Instrukcja Użytkownika Strona 46