Extron-electronics MLA-VC10 Instrukcja Użytkownika Pobierz pdf (Strona 6)

MLA-VC10 • Quick Start Guide

Quick Start Guide — MLA-VC10, cont’d

QS-2

AMP/MIXER

CONTROL

CTRL

Ground ( )

To Amplifier

0 VDC to +10 VDC

The actual maximum control voltage

depends on the Configuration DIP switch

settings, but the maximum power output will

not be reached if the amplifier's control port

voltage measures more than 10 VDC.

6 feet (1.8 m) maximum

between the MLA-VC10

and the amplifier

Step 5

Connect the power cables to a power source and power on the

MLA-VC10, MLC/power supply, RS-232 host device, and ampliﬁer

or mixer.

Step 6

For most MLC units used with the MLA-VC10, conﬁgure the system

with the Global Conﬁgurator program (see page 3-2) or RS-232 (see

page 3-14). The MLC 206 is not supported by Global conﬁgurator

and the MediaLink control software (included with the MLC) must

be used (see page 3-10).

Step 7

Set the MLA-VC10’s DIP switches to match

the voltage determined in step 1. See “DIP

switches” on page 3-11, and the reference tables

on pages 3-12 and 3-13.

Step 8

Test the system by turning the volume knob on the MLC or by

sending a volume-related RS-232 command while listening for a

change in the volume level and observing the MLA-VC10’s LED

(which should blink).

Step 9

If wiring changes are needed, turn off the power and unplug

the equipment, make any necessary wiring changes (see

"Troubleshooting", page 3-17), and then restore power to the system.

When the MLA-VC10 is attached to the control port of some

ampliﬁers, the ampliﬁer's front panel volume control knob is

disabled.

MLA_VC10_

dip_switch.eps

CONFIGURATION

1 2 3 4 5 6 7 8 9 10 11 ... 51 52

Komentarze do niniejszej Instrukcji

Brak uwag

Extron-electronics MLA-VC10 Instrukcja Użytkownika Strona 6

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Sprzęt komputerowy Extron-electronics MLA-VC10