
Remote
Communication and
Control
This section provides information on:
• Connecting a Control Device
• Software Overview
• Simple Instruction Set (SIS™) Control
• Command and Response Table for SIS Commands
• Power Save Mode
Connecting a Control Device
The SME100 can be remotely controlled using one or more of the following methods.
• Use a control PC or other device that is connected to the same network as the
SME100.
• Use a control PC or other device that is connected to the SME100 using the rear panel
RS-232 connector (see the "Rear Panel Features" section on page 12).
• Use a control PC or other device that is connected to the front panel Config port (see
the "Front Panel Features" section on page 11).
Remote communications are via SIS commands (see the "Command and Response
Table for SIS Commands" section on page 133). Use a communication utility, such
as DataViewer (see "Downloading the software" on page118) or Telnet, to send
SIScommands and view the responses.
SME 100 • Remote Communication and Control 117
Komentarze do niniejszej Instrukcji